ANTISKID SYSTEM FAILURE (ANTISKID INOP CAUTION LIGHT ON, MASTER CAUTION, AND POWER BRAKE LOW PRESS CAUTION LIGHT OUT)
1. Antiskid Switch - ON.
2. SKID CONTROL and BRAKE SYSTEM Circuit Breakers - RESET.
IF LIGHT REMAINS ON
3. Antiskid Switch - OFF.
4. Multiply landing distance of Figure 4-40 by 1.4.
NOTE
•
CAUTION: DIFFERENTIAL POWER BRAKING IS AVAILABLE. HOWEVER, SINCE THE ANTISKID IS INOPERATIVE, EXCESSIVE PRESSURE ON THE BRAKE PEDALS MAY CAUSE WHEEL BRAKES TO LOCK, RESULTING IN TIRE BLOWOUT.
5. Be prepared to use the emergency brake system.
•
If the antiskid hydraulic pump fails after the accumulator pressure exceeds 750 psi, the POWER BRAKE LOW PRESS light may not illuminate until normal brakes are used.