BEFORE TAXI
1. Air Conditioner, Fans, Temperature Control - AS REQUIRED.
NOTE
•
Air conditioner switch must be in AUTO or FAN and the aft fan must be operating for the automatic cabin temperature control system to function.
2. Lights - AS REQUIRED.
•
Bulb life is extended considerably by using the RECOG/TAXI light position for taxi.
3. Avionics Power Switch - ON.
4. Passenger Advisory Lights - PASS SAFETY.
5. Pressurization - AUTO/SET DESTINATION PRESSURE ALTITUDE + 200 feet.
6. Electric Elevator Trim - CHECK and SET; (operate electric elevator trim nose up and push AP/TRIM DISC switch. Verify elevator trim wheel stops rotating. Trim should not operate while pressing only one side of the split switch. Repeat check for nose dow
7. Flaps - CHECK and SET.
a. Set flaps to ground flaps and verify both speed brakes deploy.
b. Advance the throttles to above 85% N2; verify speed brakes retract and the flaps >35° annunciator illuminates.
c. Retard throttles to idle; verify lights extinguish and speed brakes redeploy.
d. Set flaps to TAKEOFF; verify speed brakes retract.
8. Flight Controls - FREE and CORRECT.
9. Thrust Attenuators - CHECK/AUTO. Place the thrust attenuator switch in STOW; the white ATT STOW SELECTED advisory light will illuminate. Advance either throttle beyond 85% N2 with the thrust attenuator switch in STOW; the MASTER CAUTION will illuminate
10. ATIS, Clearance, Flight Management System and Charts - CHECK.
11. Takeoff Data (V1, VR, V2, VENR (VT), N1 Speed Setting, Takeoff Field Length and Weight Limits) - CONFIRM for appropriate takeoff flap setting.
12. Avionics - CHECK AND SET.